![]() The sides of the block need to be sanded or cut down.įits other 16 round SD9 magazines and Sigma too. * Both sides of the base of the block needs to be sanded to fit into the bottom of the magazines. * Needs a hole drilled in the block for the spring, or can bend the spring. This block is for the Mecgar made magazines only This block is for the US made Jericho 941 magazines * Uses glock 10/17 limiter under the follower and a Universal limiter #16 at the base of the magazine. * See Pre-made Glock limiters for factory magazines *Sides of the block need to be sanded down to fit into the base of the magazine. *the end of the base spring needs to be bent to allow the block to install correctly. The base of the block needs to be sanded down on all 4 sides This block is for the Brownells made CZ-75 15-round magazine * The front and back of the base will need to be sanded to better fit into the magazine. *The front and back of the base will need to be sanded to better fit into the magazine. * If the metal tab is broken off the locking plate with pliers then a #15 limiter will work per a customer. *Needs a notch cut in the block or the metal tab on the locking plate cut off. **This is not a complete list of compatible magazines. *Where a range is shown can use in between the two numbers for the best fit and function. The limiter can be used as a replacement for the floorplate locking plate in some magazines or used with the original magazine locking plate. Once the final desired configuration is found the limiter should be glued together with a drop of super glue or Magblock cement. This requires the use of a cutting tool such a hacksaw or flush cutting snips. Our Patented Universal Pistol Limiter is adaptable to most double stack pistol magazines. The limiter does require some fitting and cutting of the plastic block.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |